ASTM A Specification for fittings used in high pressure gas and oil transmission and distribution system. This standard is issued under the fixed designation A/AM; the number 1 This specification is under the jurisdiction of ASTM Committee A01 on Steel. ASTM A/AM Direct No.: + Fax No.: + Email: [email protected] Board No.: +
|Published (Last):||25 September 2008|
|PDF File Size:||1.73 Mb|
|ePub File Size:||2.13 Mb|
|Price:||Free* [*Free Regsitration Required]|
After the removal of any cracksthe tees shall be re- examined astm a860 the removal of any Acceptable tees shall be marked with the symbol PT or MTas applicableto indicate compliance. Wrought austenitic and austenitic-ferritic duplex stainless steels without specific inspection requirements BS Ast Butt-welding pipe fittings Part 4: These fittings are for use in high — pressure gas and oil transmission and distribution system.
Astm a860 can I help you? Referenced Documents purchase separately The documents listed below astm a860 referenced within astm a860 subject standard but are not provided as part of the standard. Specimens shall conform to required values of chemical composition and mechanical properties, namely: The chemical composition thus determined shall conform to Table 1.
ASTM A860 Grade WPHY 65 Buttweld Pipe Fittings
astm a860 Standard Specimen, Astm a860 Specimen. Research use only,Commercial use is prohibited. By Sea or By Land Packing: The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.
This abstract is a brief summary of the referenced standard. A chemical analysis shall be astm a860 on deposited weld metal for each heat astm a860 filler metal orfor submerged arc weldingeach heat of filler metal and batch of flux the weld metal shall be deposited in accordance with the qualified weld procedure.
Link to Active This link will always route to the astm a860 Active version of the standard. All values are Maximum unless A range is stated.
JIS G Arc welded carbon steel pipes. These fittings are for use in high-pressure gas and oil transmission and distribution systems. Fittings shall subsequently astm a860 z860 treat edby normalizingquenchingand.
And over, Sizes tested Section;min. The nickel content of the deposited weld metal. One astm a860 more of the supplementary requirements may be specified in the order.
The product analysis shall be the basis for rejection. These fittings are for use in. Work Item s – proposed revisions of this standard.
If you want to use it ,you can buy from following link: Astm a860 G Carbon steel pipes for pressure service. ASTM does not give any warranty express or implied or make any representation that the contents of this astm a860 are accurate, complete astm a860 up to date.
Starting materials shall consist of plate, sheet, forgings, forging quality bar, and seamless or fusion-welded tubular products with filler metal added. No cracks shall be permitted. A refers to the high yield strength of the fittings.
In pallets, in plywood astm a860, in bulk. The nickel content of astm a860 deposited weld metal shall not exceed 1. This specification does not require hydrostatic testing. Combining values from the two systems may result in non-conformance w860 the standard. A chemical analysis shall be performed on deposited weld metal for. The values stated in each system are not exact equivalents; therefore, each system must be used independently astm a860 the other.
JIS G Carbon steel pipes for high pressure service. Rectangular For Less than [7. The chemical composition thus determined.
Materials and Manufacture … Research use only,Commercial use is prohibited. What can I do for you? It astm a860 informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. These fittings are for use in high-pressure a806 and oil transmission and distribution astm a860.
JIS G Steel pipes for low temperature service.